Sansa Clip+ Firmware | Instructions | Release Notes
Mac and Linux users can connect their Clip+ in MSC mode and follow the instructions below.
MSC mode instructions:
- Turn on the Clip+
- Navigate to "Settings" on the menu of the device itself
- Next select "System Settings"
- Next, navigate to "USB Mode" and select "MSC"
Manual Firmware update
All languages are now in one firmware version. After firmware update you will need to select your Language and Region preference.
• Ensure your battery is > 50% full
• Extract the .zip file into a folder on your computer
• Once extracted, drag the Firmware file to the root directory of your Sansa Clip+
• Disconnect the Sansa Clip+ and let it begin the firmware update
• Once it finally finishes doing its update, it will turn itself off
• Turn the Clip+ on Select your language and region preference
• Once its back to the main menu, head to "Settings" > "System Settings" > "Info", and verify the "Version" is now 01.02.18
Sansa Clip+ Firmware 01.02.18 Release Notes
This firmware has several bug fixes and enhancements, as listed below. Upon completion of firmware upgrade, the device will turn off. Power on device to complete the upgrade process. If device does not initiate or complete, press & hold the Power switch for 10 seconds to reset the device and then release and press again to restart.
Enhancements:
- No new enhancement
Bugs Fixed:
- Device hangs up after finished playing special mp3 files, which contain CRC error at the end of frames
KnownIssues:
·
- Refresh database progress bar doesn’t scale with time
- FM signal is weakened during FM recording
- Powering off device is not available during Locked state
- Some language strings are in English
- Have to remove 200MB to allow enough space for DB rebuilding
- Voice deletion in MSC mode doesn’t clean out filename