I’m looking for advice on how I can get my new SSD to run as the boot drive.
I purchased a WD Blue 3D NAND SSD to replace a Hitachi HHD on my desk top with a MSI H55M-E23 motherboard.
I installed and cloned the SSD drive using Macrium Reflect. Both drives are 1T and are just over half full after cloning.
I initialized the drive, set a drive letter and change the boot sequence so the SSD is the primary boot.
The system boots to my old HDD. I even change the internal wires on the motherboard so the SSD was plugged where the HDD was and vice versa with same result.
When I unplug the HDD from the motherboard - I get error message: “Reboot and select proper boot device or insert boot media in selected boot device and press a key”. I also unplugged the DVD drive with the same result.
Once and only once during the many reboot attempt did I get the initial black screen with the blue windows logo without hearing the pitter-patter of the HHD. Unfortunately the logo remained on my screen for over 5 minutes when I rebooted and it booted to the HHD again.
When both drives are plugged in and the system boot with the HHD, both the SSD drive and HDD are recognized and display in the device manager and file explorer without error messages
The fix for how I can use the new SSD as a boot drive would be much appreciated? MY HHD is painfully slow and runs constantly.
Many thanks!
Michael
New SSD will not boot
5 replies