About Ratings
Memory cards use Speed Rating and Class Rating to promote the highest and lowest speeds the card can get.
Speed Rating
This is the maximum transfer speed for reading and writing images to and from a memory card.
It is expressed as megabytes per second (MB/s).
This speed is important for photographers with high-resolution cameras.
The faster the card, the faster it can save the file and be ready to take another picture.
This is noticed when using multi-shot burst mode as it can save more photos before running out the buffer.
Higher speed cards can also transfer files to and from the computer quicker.
Video format is a smaller fixed stream that uses only a portion of the speed.
Class Ratings
This is the minimum sustained speed needed for recording an even rate of video.
The class rating number is the transfer rate measured in megabytes per second (MB/s).
Class 2 cards are designed for a minimum sustained transfer rate of 2MB/s.
While Class 10 cards are designed for a minimum sustained transfer rate of 10 MB/s.
The Speed Class is important for video where the device is saving a steady stream of data.
The resolution and format of the video affects the speed of the data.
The minimum speed needed makes sure that the video captured is saved at an even sustained rate with no dropped frames.
A slow speed class card can result in lost data and choppy playback.
The camera's specs should state the minimum SDHC Class Rating required.
Note:
Using a card without the proper class rating is likely to cause an error message:
Video can only be recorded at a lower definition setting.
The current SDHC spec defines Class 2, 4, 6, 8, and 10 as follows:
UHS Speed Class
It is designed for SDHC and SDXC memory cards.
This data bus will not work in non-UHS host devices.
The device will default to the standard data bus and use the Speed Class rating if a UHS memory card is used in a non-UHS host.
UHS memory cards have a full higher potential of recording real time broadcasts.
They can capture large-size HD videos.
Sandisk Support article 9064. View the original article on Sandisk Support