Problem
Error 0x8007045D can happen when adding data to a USB flash, external drive, or memory card.
This is normally caused by:
- Not using Safe Eject.
- Abrupt power loss to the drive.
- File system issue.
- Bad or loose USB port and cable.
- Drive has errors or failed.
Solution
- Always use Safe Eject before removing the drive.
Eject and remove when not using it.
Need more help? - Make sure USB connections are secure and tight.
Try a different cable. - Check the drive for errors.
Repair the file system.
Need more help?
How to Check External, USB Flash Drive, and Memory Cards for Errors or Failure with Windows Diagnostic Programs -
Erase the drive before formatting again if data recovery is not needed.
Warning: This process erases all data on the drive. Back up your data before you continue.
Need more help?
Self Help Third-Party Data Recovery
Need more help?
Self Help Third-Party Data Recovery Software for Windows and macOS
Data Recovery Service
Warranty Replacement
Need more help?
Steps to Get a Sandisk Warranty Replacement for a Product, Power Supply, or USB Cable
Sandisk Support article 52429. View the original article on Sandisk Support