Problem
Power Surge on Hub Port or USB device has exceeded the power limits of its hub port is seen.
Some hardware only allow a max of 500 milliamps (mA) per drive.
Solution
Power Message
The message does not mean the USB port is bad.
The drive should still work as normal.
Use these steps to turn off the message.
Note:
Some external drives need at least 650 milliamps (3.25 Watts).
Powered Hub
Use a Powered USB Hub if the computer is limited to 500 mA or the error message continues.
Windows 11, 10
- Click Start.
- Click Control Panel.
- Double-click System and Security.
- Click Device Manager.
It is under the System. - Open Universal Serial Bus Controllers.
- Right-click USB Enhanced Host Controller.
Select Properties. - Click Advanced Tab.
- Check the box that says: Don't tell me about USB errors.
Click Ok.
Sandisk Support article 16704. View the original article on Sandisk Support