Learn About PRO-G40 SSD USB Drive Not Detected and Host Power Requirements

Problem

The PRO-G40 SSD is not detected by Windows, macOS, or other host device.

It is a high-performance portable drive that supports Thunderbolt 3 and USB 3.2 Gen 2 USB-C (10Gbps).


Note:

  • It comes with a Thunderbolt 3 cable.

  • Supports USB 3.2 Gen 2 USB-C (10Gbps).
    A high quality USB 3.2 Gen2 rated cable is required. (not included)

  • A minimum of (5 Volts - 3 Amps) is needed at all times!

  • Phones, tablets, Chromebooks, and low power laptops may not provide enough power.


Solution



  1. Stop the SANDISK Dashboard software if installed.
    This will prevent it from polling the drive.

  2. Make sure the host computer is plugged into a power outlet.
    It cannot be on battery power.

  3. Make sure the host system can provide enough power.
    Some hosts reduce power to the port after boot-up or initial drive connection.

    A minimum of (5 Volts - 3 Amps) is needed at all times!


  4. Connect the drive directly to the Thunderbolt 3 port with the Lightning Bolt.

    Thunderbolt 3 and 4 PortUSB-C Only

    Need more help?
    Learn Why an External Thunderbolt Drive is Not Detected

  5. Use the cable that came with the drive.

  6. Format the drive as APFS when used on macOS.
    Format the drive as NTFS when used on Windows.
    (default = APFS and will not mount on Windows)

    Need more help?
    Quick Steps to Format an External, USB Flash Drive, and Memory Card on Windows and macOS

  7. Use a third-party powered USB hub, docking station capable of supplying 5 Volts - 3 Amps or more at all times.

  8. Set the computer to not sleep.
    The port may not provide enough power after wake up from sleep.

    Need more help?
    Instructions to Prevent an External Drive from Going Into Sleep or Standby Mode on Windows and macOS


Sandisk Support article 34968. View the original article on Sandisk Support