Learn About Slow Data Transfer and Power On Times with a G-RAID, G-SPEED SHUTTLE SSD

Problem

Transfer speeds and power on time can slow down for these reasons:

  • Drive capacity full
  • Computer OS drive full
  • Damaged cable
  • Plugged into a non-compatible port
  • The chassis shows a red LED
  • RAID is synchronizing
  • RAID rebuild needed
  • Degraded drive and shows a red LED

    Need more help?
    Learn About G-RAID SHUTTLE SSD LED Behavior


Third-Party speed test software can be used to measure transfer rates.



Solution

G-RAID Software

  1. Use G-RAID Software Utility to see if the RAID is synchronizing or any other activity.

    Need more help?
    Steps to Download and Install G-RAID Software Utility for G-RAID, G-SPEED SHUTTLE SSD

  2. Make sure the drives are not full.

  3. Make sure the computer OS drive is not full.

    Note:

    10-15% free space is recommended for optimal performance.

  4. Try a different or cable.

  5. See computer maker details to confirm compatible ports.

    Important:


    Connecting to a non-compatible port may still mount but will perform slower.


Test Drives

Drives can be tested if the device is performing slowly with no red lights.

Warning: This process erases all data on the drive. Back up your data before you continue.

  1. Remove all drives.

  2. Insert one drive.
    Run a speed test.

  3. Write down the speed rates.

  4. Remove the drive.
    Insert the next drive.
    Run the speed test.

  5. Repeat steps 3 & 4 until all drives are tested.

Replace any drive that has much slower speed than the rest.


RAID Rebuild

A RAID rebuild may be needed.

Warning: This process erases all data on the drive. Back up your data before you continue.

Need more help?
How to Rebuild and Fix Degraded RAID for G-RAID, G-SPEED SHUTTLE SSD


Warranty Replacement

The drive can be replaced if it is under warranty.

Need more help?
Steps to Get a Sandisk Warranty Replacement for a Product, Power Supply, or USB Cable


Sandisk Support article 50641. View the original article on Sandisk Support