About Drives
Drives can be damaged by too much physical force or from Electrostatic Discharge (ESD).
Special handling is required to protect them from damage.
Special handling is required to protect them from damage.
Note:
ESD damage is invisible to the eye and may not be discovered until later by way of slow performance or failure. Use these steps to reduce the chance of damage.
Do
- Get tools ready before removing the drive from the packaging.
- Stand on a rubber mat when installing drives.
- Keep the drive inside the package until it is ready to be installed.
- Wear a grounding strap when working near sensitive devices like memory, controller cards, or other electronic boards.
- Power off the computer but leave the power cable pulled in.
- Touch bare metal on computer case.
Remove the power plug. - Hold drives by the sides.
- Be careful when installing data and power connectors to avoid damaging connector pins.
Do Not
- Avoid subjecting the drive to extreme temperatures.
- DO NOT touch the connectors or the Printed Circuit Board.
- DO NOT walk or stand on carpet.
They generate static electricity. - DO NOT drop, jolt, or shake the drive.
This will damage the drive. - DO NOT let people touch the drive.
- DO NOT stack drives.
- DO NOT stand drives on its side.
- DO NOT place anything on top of a drive.
- DO NOT force or hammer a drive into a bay or slot.
- DO NOT force or hammer drive connections.
Sandisk Support article 16889. View the original article on Sandisk Support