About Codes
The error codes are an output from a self-test from within SANDISK Dashboard.
Error Codes for NVMe Drives
Note:
Retest after checking connections and replace drive if error repeats.
|
Error code
|
Definition
|
|---|
| 0 | Success. |
| 1 | Process was stopped by a self-test command. |
| 2 | Process was stopped by a Controller Level Reset. |
| 3 | Process was stopped due to a removal of a namespace. |
| 4 | Process was stopped during a Format NVM command. |
| 5 | A fatal error occurred while the controller was doing the device self-test process. |
| 6 | Process finished with an unknown segment failure. |
| 7 | Process finished with one or more failed segments. |
| 8 | Process was stopped for an unknown reason. |
| 9 | Process was stopped due to a sanitize command. |
Error Codes for SATA Drives
Note:
Retest after checking connections and replace drive if error repeats.
|
Error Code
|
Definition
|
|---|
| 0 | Success. |
| 1 | The self-test was stopped by the host. |
| 2 | The self-test was stopped with a hardware or software reset. |
| 3 | A fatal error occurred while the controller was doing the device self-test process. |
| 4 | The self-test failed with an unknown test element. |
| 5 | The self-test failed with the electrical element. |
| 6 | The self-test failed with the servo or the seek test. |
| 7 | The self-test failed with the read element. |
| 8 | The self-test failed and the device may have handling damage. |
Warranty and Data Recovery
Need more help?
Sandisk Warranty Replacement and Data Recovery
Sandisk Support article 32313. View the original article on Sandisk Support