Setup As New Option Not Available
There is a chance that the new User will not see Setup as New when setting up.
Factory Reset the drive.
When attached the ArmorLock will send a Bluetooth signal to check for registered devices nearby.
The User will not get the option Setup as New if there is a registered phone or computer in range.
Note:
This is a safety feature to ensure the data on the ArmorLock is protected from being erased accidentally.
Drive Not Mounting With Always Unlocked Enabled
The drive is unlocked but not mounting.
The drive volume may be corrupted due to a .
- Check Always Unlocked is disabled.
- Safely eject the drive and plug it back in.
- Standby and allow the system to attempt to repair the dirty bit.
It may take several minutes and safely ejecting and replugging a few times may be required. - Try to repair it with Disk Utility First Aid on macOS or Error Checking Tool on Windows.
Critical:
Data Recovery is not possible with ArmorLock due to the nature of its security
Perform a Secure Erase in ArmorLock App to continue using the drive.
- Open the ArmorLock App.
- Select gear icon.
- Select Secure Erase.
Select the drive format.
Confirm the choice.
Request Access Not Available
Manager selected Update Later during a Firmware update notification.
A new User may have an issue Requesting Access to ArmorLock device.
The Manager will not see the request and will not be able to Authorize the user.
The Manager will need to re-open the App to get the request.
- Quit the ArmorLock App.
- Check it's not running in the background.
- Open the App.
Approve the Request.
Partitioning on ArmorLock App
The App will default to MBR (Master Boot Record) when formatting as exFAT.
Partitioning will only work on the GUID/GPT scheme.
Steps to change the scheme.
- Open the ArmorLock App.
- Select gear icon.
- Select Secure Erase.
Select the drive format.
Confirm the choice. - Change the partition scheme and reformat the drive through Disk Utility on macOS or Disk Management on Windows.
Need more help?
Steps to Format a Drive for Use with Windows or macOS
Host Device Support
The ArmorLock device will only work when attached to a Windows or macOS computer.
The drive does not support plugging into tablets or phone directly.
USB hubs are NOT supported.
Maximum number of drives supported by Manager
There is support for a maximum of 254 drives and authorized users.
Sandisk Support article 34428. View the original article on Sandisk Support