Steps to Resolve My Passport Wireless SSD Battery Is Not Charging


Problem

My Passport Wireless SSD battery is not charging.
The dashboard displays < 5 % charge or only the first LED is illuminated.

Cause

The My Passport Wireless SSD will not charge under the following conditions:

  • Connected to your computer with a USB cable and the USB port doesn’t provide enough power to charge the battery
  • An external USB device attached to the unit
  • Drive is in use and does not go into suspend mode
    • DLNA Twonky Media Server is indexing content
    • Plex Media Server downloading and indexing content

Solution

Please follow the steps below to allow the battery to charge.

  1. Safely eject any USB attached devices and remove SD cards and or Readers.

  2. Log into the My Passport Wireless SSD Dashboard

    For assistance accessing the dashboard, please reference Answer ID 13879 How to access the Dashboard on a My Passport Wireless device

    • Select the Media Tab
    • Turn off Plex and or DLNA Media Server

  3. Press the units power button and Power OFF the device

  4. Connect the My Passport Wireless SSD device to the supplied +5 Volt USB Cable and 5 Volt 2.4 Amp Power Adapter.


  5. Allow the My Passport Wireless SSD to charge for 2 to 4 hours or until the First LED is fully illuminated, 20 % charge.

  6. Press the units power button and Power OFF the device again.

  7. Allow the My Passport Wireless SSD to charge for 4 to 6 hours in Powered Off Mode or until Three LED are illuminated, 75 % charge, before powering on the unit.


  8. If the battery does not charge or does not hold a charge at all, please submit an online Warranty Replacement if the unit is still within warranty as indicated below.

Warranty Replacement & Data Recovery


If the drive is failed or damaged, please do the following:

Warranty Replacement


Data Recovery

Return to Top



Sandisk Support article 8126. View the original article on Sandisk Support