Why are you not showing all drive letters in Dashboard app?

I made an observation in the WD “Dashboard” app today. I’m a perfectionist, so I am a little disappointed and decided to write about it, in hope that someone responsible at WD will read it.

  • I have several partitions, including partition G, on a WD Red 4 TB HDD, GPT.

  • I have a partition K on a WD Caviar Black 1 TB HDD, MBR.

  • I have the partitions L and M on a second WD Caviar Black 1 TB HDD, GPT.

  • I most recently added a WD SSD as my C system disk, the WD Black SN850X 1 TB SSD, GPT.

When I view them in the app, they appear as K, G, M, and C. I found this a bit confusing, thinking that the app didn’t find all the drives. But then I realized that it’s just using a single drive letter for each item in the menu, one for each drive, ignoring the other drive letters.

It seems to pick up on the last drive letter, so if a drive has two partitions L and M, it will appear as M. But if it has three, or four, or more drive letters, then it seems to get confused and picks up a drive letter at random. In my case, I have 9 partitions at the moment, and it picked up on drive letter G. I’m not sure why. The last two partitions were added after Dashboard app was installed, but it still didn’t pick up on what was the last drive letter prior to installing the software, which would have been drive letter I (no not me, “I” as in "I:\" 😕 ). So I have given that a thought too! It seems to be picking up on these at random. I just hope it sticks to whatever it has decided to use, so it stays the same between power cycles - I haven’t tested this to verify that it does.

Why not display all drive letters though? Even if a single hard drive has 2, 3, 4, or even 9 partitions? I have many partitions, yes. Don’t you? I don’t see Windows or Task Manager complaining when it prints out "Disk 2 (L: M:)". Especially if you have not labeled your partitions properly like I have (e.g. Photos (WD Black 2)), identifying it in the Dashboard software by one of those drive letters that are hidden from view is made unnecessarily difficult.

So if WD would kindly fix this up, at the expense of slightly less clean and sexy (and also empty) GUI, someone here will very much appreciate that. 🙂

6 replies