I just installed the new (internal) 1TB WD hard drive I got for Christmas. I loaded it with a clean install of Windows 7. I figured that before I got too much stuff on it I would run Macrium Reflect and do a image backup. It didn’t verify as a good image. I went into the event viewer and here were a ton of this code 33 sidebyside errors.
I asked on the windows 7 forum and they said it was a conflict, that the version shown is not the version I have. When I installed the external HD (My Book Essential 2.0) would it still have the old updates of the firmware and software?
How do I fix this so I can do a full C drive backup? I prefer the Macrium to the Acronis. With Macrium I can backup file by file if I want, with Acronis I have to back up the whole drive. Same with the Windows 7 Pro. There are times I just want to back up a section of a file.
I uninstalled the SmartWare through the control panel, but it didn’t make a difference. Anybody else getting this??