I used my SanDisk Ultra 3.0 / 256 gb for the purpose of creating a Windows Recovery Drive. I didn’t realize this would make this drive worthless for any other purpose. I only needed 16 GB . The drive was formatted by this process to read only 32 GB and could not be formatted using Windows options. SanDisk customer support advised there was software which could restore the drive to it’s original configuration. http://kb.sandisk.com/app/answers/detail/a_id/19258/ I downloaded the software following the instruction. The pop up in the software under Formatting Options showed quick format and two others which I can’t remember . No Full Formatting option offered. I ran the software with the quick format option checked as it was when I opened the software. It didn’t work. After running it twice , the drive which was 256 GB showed only about half of the drive was free. The other half had no information in it ?? I went back to the software and ran it again. This time I unchecked the quick format option box . This left NO BOXES checked. I ran the software . It is running very slowly . Only about half done . One hour has passed. I don’t know if this will work . I wish the instructions for the software " HP USB Disk Format Tool to format SanDisk USB drives" had better instructions for use. I don’t know if it will be successful or not yet. I hope so. If someone can access a complete set of instructions for the use of this software it would be great. I tried but couldn’t find them.
RESTORATION OF SANDISK ULTRA FLASH DRIVES
2 replies